Volume of bass sound is insufficient - AF82.62-P-1008A

MODEL 211.2## 1A up to 295172 with CODE (810) Sound system

OPERATION NO. OF OPERATION TEXTS OR STANDARD TEXTS AND FLAT RATES

Category	Op. no.	Operation text	Time	Acc. no.	Code
P	024029	Exchange connectors at bass box	002 WU	-	-

Damage code	Cause	Remedy
	Hardware fault in bass box.	Do not remove/install or replace any parts!
	This will cause poor sound quality and insufficient bass in the sound system.	The bass box speaker is located under the right inner paneling at the side in the load compartment
		1 Remove right inner side paneling of load compartment.	AR68.30-P-1180T
			Figure
		Connect the pins at the bass box connector as follows: ↓ 2 Switch pins 1 and 2 at the speaker's coil.
		3 Switch pins 2 and 4 at the speaker's coil.
		4 Install right inner side paneling of load compartment.	AR68.30-P-1180T
		Bass boxes with release Q2 are OK as of CW 18/03.

Fig 1: Identifying Mounting Wedge (110 589 03 59 00)

G04987562