Protect repair area after cable repairs - AR00.19-P-0100-08A

WARNING: This page is about a different car, the 2009 Mercedes-Benz CLK350 and 2008 Mercedes-Benz CLK350. However, it is still accessible from the selected car via links, so may be relevant.

Protection of repair area with heat-shrinkable tube

Slide heat-shrinkable tube over the repair area.
Heat the heat-shrinkable tube using hot air blower until it lies evenly against the repair area.
Hot air blower

gotis://E_15.54_12.0

Fig 1: Heating Heat-Shrinkable Tube
Courtesy of MERCEDES-BENZ USA

Protection of repair point by corrugated hose.

Lay corrugated hose over repair point.
Wrap insulation tape around corrugated hose at both ends.

Fig 2: Wrapping Insulation Tape Around Corrugated Hose
Courtesy of MERCEDES-BENZ USA

Protection of repair point by wrapping round fabric tape.

Wind fabric tape around the repair point as per the original condition.
Primarily fabric tape is used for the visual adaptation of the repair point and to protect against chafing. In vehicle areas with higher loads (e.g. engine compartment), fabric tape should only be used in combination with other (watertight) safety measures.