Remove paneling in trunk - AR68.30-P-4600PB
WARNING: This page is about a different car, the 2009 Mercedes-Benz CLK350 and 2008 Mercedes-Benz CLK350. However, it is still accessible from the selected car via links, so may be relevant.
MODEL 203.7, 209.3
MODIFICATION NOTES
| 24.1.01 | "Unclip trunk floor paneling (1)" added | Step 1 |
| Remove/install | |||
| 1 | Unclip trunk floor paneling (1) and remove | ||
| 2.1 | Remove screw (10) | MODEL 203.7 with CODE (854) MB cell phone | |
| 3 | Remove screws (9) on both sides | *BA68.50-P-1002-03A | |
| 4 | Remove anchoring lug (8) on both sides. | ||
| 5 | Remove cover behind rear seat (7) | ||
| 6 | Remove expansion clips (3) from bottom rear center section paneling (2) | ||
| 7 | Remove bottom rear center section paneling (2) | ||
| 8 | Unclip clips (4) from left paneling (5) | ||
| 9 | Remove trunk illumination coupling | ||
| 10 | Remove left paneling (5) | ||
| 11 | Unclip clips (4) from right paneling (6) | ||
| 12 | Remove right paneling (6) | ||
| 13 | Install in the reverse order |
CARGO RETAINERS
| Number | Designation | Model 203 | Model 209 | |
|---|---|---|---|---|
| BA68.50-P-1002-03A | Bolt, front trunk anchoring lug | Nm | 20 | 20 |