Separate oil-pump chain - AR18.10-P-2140-01TX

WARNING: This page is about a different car, the 2009 Mercedes-Benz CLK350 and 2008 Mercedes-Benz CLK350. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Case (602 589 00 98 00)

Courtesy of MERCEDES-BENZ USA

Fig 2: Identifying Thrust Spindle (271 589 10 63 00)

Courtesy of MERCEDES-BENZ USA

Fig 3: Identifying Chain Separating Tool (602 589 02 33 00)

Courtesy of MERCEDES-BENZ USA

Screw the pressure screw (02) with the pressure pin (02a) into the chain separating tool (03).
Fit chain separating tool (03) onto oil pump chain.
Turn in pressure screw (02).
Turn in until the pressure pin (02a) contacts the bolt on the oil pump chain (arrow).
Turn in pressure pin (02a) and press out bolt of oil pump chain.

Fig 4: Turning Pressure Screw
Courtesy of MERCEDES-BENZ USA
Unscrew pressure screw (02) and remove chain separating tool (03).
Remove bolt (1) of oil pump chain from chain separating tool (03).

Fig 5: Removing Bolt Of Oil Pump Chain From Chain Separating Tool
Courtesy of MERCEDES-BENZ USA