LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 2003 >> CLK500 >> Repair and Diagnosis >> External Pages >> Different car >> Section 313 (Lubrication, Oil Cooling -- CLK350 Coupe (209.356)) >> Testing & Repair >> Remove/install oil pump - AR18.10-P-6020QB

Remove/install oil pump - AR18.10-P-6020QB

WARNING: This page is about a different car, the 2009 Mercedes-Benz CLK350 and 2008 Mercedes-Benz CLK350. However, it is still accessible from the selected car via links, so may be relevant.

ENGINE 272.920 in MODEL 203.052/252/752 

ENGINE 272.940 in MODEL 203.054/254, 209.354/454 

ENGINE 272.960 in MODEL 203.056/256/756, 209.356/456 

ENGINE 273 in MODEL 209 

Fig 1: Identifying Oil Pump Components
G07716477Courtesy of MERCEDES-BENZ USA
REMOVINGINSTALLING Remove/install    
DANGER Risk of death  caused by vehicle slipping or toppling off of the lifting platform. Align vehicle between the columns of the lifting platform and position the four support plates at the lifting platform support points specified by the vehicle manufacturer. AS00.00-Z-0010-01A
DANGER Risk of accident  caused by vehicle starting off by itself when engine is running. Risk of injury  caused by contusions and burns during starting procedure or when working near the running engine Secure vehicle to prevent it from moving by itself. AS00.00-Z-0005-01A
    Wear closed and snug-fitting work clothes.  
    Do not grasp hot or rotating parts.  
1 Remove oil pan   AR01.45-P-7500QB
2 Remove the oil suction pipe (1) from the crankcase, for this step unscrew bolts (2) SPECIAL TOOL *BA18.10-P-1005-01B 
    SPECIAL TOOL External torx set *001589760900
3 Remove the oil pump (3) from the crankcase, for this purpose unscrew bolts (4, 5) TORQUE SPECIFICATION *BA18.10-P-1008-01B 
    SPECIAL TOOL Torx bit set *000589011000
4 Press the chain tensioner (6) to the back, remove the oil pump chain (7) from the oil pump gear (8) and take out the oil pump (3) together with the oil suction pipe (1) IMPORTANTInstallation:  Fill oil pump (3) with engine oil before installing so that it immediately pumps oil when first started.  
5 Install in the reverse order    
6 Check engine oil level approx. 5 minutes after switching off the warm engine, if required adjust to correct level NOTES The vehicle must be positioned horizontally on the wheels, otherwise false measurements occur.  
7 Carry out an engine test run and check the engine for leaks    
OIL PUMP

Number Designation Engine 272 Engine 273
BA18.10-P-1005-01B Oil suction pipe to crankcase   Nm 9 9
BA18.10-P-1008-01B Bolt, oil pump at crankcase Stage 1 Nm 5 5
Stage 2 Nm 20 20
Fig 2: Identifying Torx Bit Set (000 589 01 10 00)
G07499445Courtesy of MERCEDES-BENZ USA
Fig 3: Identifying External Torx Set (001 589 76 09 00)
G07716479Courtesy of MERCEDES-BENZ USA