Remove/install paneling in trunk. - AR68.30-P-4600PB
MODEL 203.7, 209.3
MODIFICATION NOTES
| 24.1.01 | Unclipping trunk floor paneling (1) added | Step 1 |
| Remove/Install | |||
|---|---|---|---|
| 1 | Unclip trunk floor paneling (1) and take out | ||
| 2.1 | Unscrew bolt (10) | Model 203.7 with code (854) MB portable CTEL | |
| 3 | Unscrew bolts (9) on both sides | *BA68.50-P-1002-03A | |
| 4 | Take out anchoring lug (8) on both sides | ||
| 5 | Remove cover behind rear seat (7) | ||
| 6 | Remove spreading clips (3) from bottom rear center section paneling (2) | ||
| 7 | Remove bottom rear center section paneling (2) | ||
| 8 | Unclip clips (4) from left paneling (5) | ||
| 9 | Disconnect trunk lamp connector | ||
| 10 | Remove left paneling (5) | ||
| 11 | Unclip clips (4) from right paneling (6) | ||
| 12 | Remove right paneling (6) | ||
| 13 | Install in the reverse order |
LOAD RETAINER
| Number | Designation | Model 203 | Model 209 | |
|---|---|---|---|---|
| BA68.50-P-1002-03A | Screw for anchoring lug at front in trunk. | Nm | 20 | 20 |