Remove/install headlamp range adjustment front axle sensor - AR82.10-P-4083Q

MODEL 209 

with CODE (614) Bi-xenon headlamp unit 

except CODE (P98) Black Series 

MODEL 209 as of 17.5.05 

with CODE (615) Bi-xenon headlamp unit with integrated curve illumination 

except CODE (P98) Black Series 

Fig 1: Identifying Headlamp Range Adjustment Front Axle Sensor Components

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

	Remove/install
	Risk of death  caused by vehicle slipping or toppling off of the lifting platform.	Align vehicle between columns of vehicle lift and position four support plates at vehicle lift support points specified by vehicle manufacturer.	AS00.00-Z-0010-01A
1	Raise vehicle		AR00.60-P-1000P
2.1	Remove bottom engine compartment paneling at front	Vehicles with gasoline engine	AR61.20-P-1105P
2.2	Remove bottom part of noise encapsulation at the front.	Vehicles with diesel engine	AR94.30-P-5300P
3	Unscrew nut (2)	Replace self-locking nut (2) to ensure that the front axle sensor for the headlamp range adjustment (A52) does not work its way loose.
4	Remove linkage (1) on front axle sensor for headlamp range adjustment (A52)	Installation:  Check linkage (1) for wear and replace if necessary.
5	Detach electrical connector (4)
6	Unscrew nuts (3)
7	Remove right front level sensor (B22/8)
8	Install in the reverse order
9	Check headlamp setting and correct if necessary
	Check and correct headlamp adjustment		AP82.10-P-8260P