Remove/install antenna - AR82.70-P-8951P: Notes

MODEL 203.0, 209.3 with CODE (354) Telephone antenna (D and E nets) with CODE (387) Pre-installation for telephone "Handy", UPCI system, USA/Canada with CODE (359) TELE AID emergency call system with CODE (529) HIGH Class Japan with CODE (534) Audio 20 CD radio, Japan 

Fig 1: Identifying Antenna Components

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

Shown on right C-pillar 

Fig 2: Identifying Antenna Systems Connector - Shown On Right C-Pillar

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

	Remove/install
	Information on preventing damage to electronic components due to electrostatic discharge		AH54.00-P-0001-01A
1	Detach headliner and place down to front	Model 203.0	AR68.30-P-4300P
		Model 209.3	AR68.30-P-4300Q
2	Remove antenna systems connector (X1/16) from bracket on right C-pillar and detach
3	Detach telephone antenna connector (3) and antenna base (2) from rear window (4)	Carefully heat repair area using hot air gun. Installation:  When gluing on telephone antenna (A2/22), make sure that after removing the protective foil on the adhesive pad, it is stuck to the rear window (4) immediately. Once positioned, apply pressure to the telephone antenna (A2/22) for approx. 5 s.	AR82.62-P-8951-01P
			Fig 3
			*WH58.30-Z-1004-20A
4	Remove adhesive residues from rear window	Use activator.	*BR00.45-Z-1023-04A
		Apply bonding agent to bonding surface on rear window and allow to flash off for approx. 1 minute before gluing on the antenna.	*BR00.45-Z-1019-02A
5	Install in the reverse order

Special tools 

Fig 3: Identifying Mounting Wedge (110 589 03 59 00)

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.