Special tools: Passenger cars: Part numbers 210 - WS00.01-Z-9210AZ
WARNING: This page is about a different car, the 2009 Mercedes-Benz CLK350 and 2008 Mercedes-Benz CLK350. However, it is still accessible from the selected car via links, so may be relevant.
MODEL all
| 210 589 00 07 00 Claw-type wrench for rosette on ignition/starter switch | FG 46/68/80/27/Set B | WS46.00-P-0065B |
| 210 589 00 09 00 Socket wrench bit | FG 32/Set B | WS32.00-P-0050B |
| 210 589 00 14 00 Sleeve | FG 46/Set C | WS46.00-P-0077C |
| 210 589 00 15 00 Drift punch | FG 33/Set B | WS33.00-P-0061B |
| 210 589 00 16 00 Connection piece | FG 22/Set B | WS22.00-P-0005B |
| 210 589 00 23 00 Pulling device for rear end center assembly | FG 64/Set K | WS64.00-P-0015K |
| 210 589 00 37 00 Pliers | FG 26/Set B | WS26.00-P-0051B |
| 210 589 00 37 00 Pliers | FG 27/Set B | WS27.00-P-0054B |
| 210 589 00 40 00 Magnetic pin | FG 05/15/Set B | WS05.00-P-0155B |
| 210 589 00 43 00 Extraction and insertion tool | FG 33/Set C | WS33.00-P-0057C |
| 210 589 00 43 04 Thrust piece | FG33/Set C | WS33.00-P-0057-04C |
| 210 589 00 43 94 Repair spindle, short | FG33/Set C | WS33.00-P-0057-03C |
| 210 589 00 43 95 Repair spindle, long | FG33/Set C | WS33.00-P-0057-05C |
| 210 589 00 43 96 Repair spindle, short | FG33/Set C | WS33.00-P-0057-06C |
| 210 589 00 43 97 Repair spindle, long | FG33/Set C | WS33.00-P-0057-07C |
| 210 589 00 43 98 Repair kit | FG33/Set C | WS33.00-P-0057-01C |
| 210 589 00 43 99 Repair kit | FG33/Set C | WS33.00-P-0057-02C |
| 210 589 00 61 00 Supports for engine support bracket (2 each) | FG 60/Set K | WS60.00-P-0080K |
| 210 589 00 63 00 29-pin test cable | FG 83/Set B | WS83.00-P-0027B |
| 210 589 00 66 00 Device | Group 72/Set K | WS72.00-P-0035K |
| 210 589 00 66 01 Spacer | FG72/Set K | WS72.00-P-0035-01K |
| 210 589 00 66 02 Cutting wheel | FG72/Set K | WS72.00-P-0035-02K |
| 210 589 00 66 03 Guard hood | FG72/Set K | WS72.00-P-0035-03K |
| 210 589 00 71 00 Hand pump | FG 00/01/07/09/20/25/27/32/33/43/46/88 | WS00.00-P-0280Z |
| 210 589 00 72 00 Hollow cavity set | FG 98/Set K | WS98.00-P-0010K |
| 210 589 00 91 00 Test cap | FG 20/Set B | WS20.00-P-0017B |
| 210 589 01 07 00 Puller | FG 47/Set B | WS47.00-P-0004B |
| 210 589 01 14 00 Guide sleeve | FG 46/Set C | WS46.00-P-0082C |
| 210 589 01 15 00 Drift | FG 33/Set B | WS33.00-P-0062B |
| 210 589 01 16 00 Four-point drive | FG 22/05/Set B | WS22.00-P-0006B |
| 210 589 01 23 00 Check and welding gauge for front reinforcement | FG 62/Set K | WS62.00-P-0042K |
| 210 589 01 31 00 Assembly template | FG 26/Set C | WS26.00-P-0078C |
| 210 589 01 37 00 Pliers | FG 47/Set B | WS47.00-P-0010B |
| 210 589 01 40 00 Bracket | FG 35/Set C | WS35.00-P-0160C |
| 210 589 01 43 00 Puller and installation tool | FG 35/Set C | WS35.00-P-0146C |
| 210 589 01 62 00 Assembly adapter | FG 33/Set B | WS33.00-P-0065B |
| 210 589 01 63 00 78-pin test cable | FG 82/Set B | WS82.00-P-0008B |
| 210 589 02 15 00 Drift | FG 26/Set B | WS26.00-P-0074B |
| 210 589 02 21 00 Left centering gauge | FG 72/Set K | WS72.00-P-0020K |
| 210 589 02 23 00 Puller for wishbone mount and shock absorber console | FG 62/Set K | WS62.00-P-0040K |
| 210 589 02 40 00 Retainer wrench | FG 28/Set B | WS28.00-P-0061B |
| 210 589 02 40 00 Retainer wrench | FG 33/Set B | WS33.00-P-0063B |
| 210 589 02 43 00 Extraction and insertion tool | FG 35/Set C | WS35.00-P-0147C |
| 210 589 03 15 00 Drift | FG 26/Set B | WS26.00-P-0075B |
| 210 589 03 21 00 Right centering gauge | FG 72/Set K | WS72.00-P-0021K |
| 210 589 03 23 00 Pulling device for front longitudinal member | FG 62/Set K | WS62.00-P-0041K |
| 210 589 03 43 00 Extraction and insertion tool | FG 33/Set B | WS33.00-P-0115B |
| 210 589 03 43 00 Extraction and insertion tool | FG 35/Set C | WS35.00-P-0154C |
| 210 589 03 43 09 Pin | FG35/Set C | WS35.00-P-0154-01C |
| 210 589 03 63 00 Adapter | FG 20/Set B | WS20.00-P-0019B |
| 210 589 04 15 00 Drift | FG 26/Set B | WS26.00-P-0076B |
| 210 589 04 23 00 Set of test and welding gauges | FG 60/63/Set K | WS63.00-P-0058K |
| 210 589 04 33 00 Assembly tool I | FG 82/Set B | WS82.00-P-0010B |
| 210 589 04 43 00 Extractor tool | FG 35/Set C | WS35.00-P-0159C |
| 210 589 04 63 00 Thrust piece M 10x1.5 | FG 35/Set B | WS35.00-P-0230B |
| 210 589 04 63 00 Thrust washer, M 10x1.5 | FG 33/Set B | WS33.00-P-0058B |
| 210 589 04 63 00 Thrust washer, M 10x1.5 | FG 82/Set B | WS82.00-P-0135B |
| 210 589 05 15 00 Drift | FG 46/Set C | WS46.00-P-0078C |
| 210 589 05 23 00 Template for left B-pillar | FG 63/Set K | WS63.00-P-0050K |
| 210 589 05 33 00 Assembly tool II | FG 82/Set B | WS82.00-P-0011B |
| 210 589 05 43 00 Removal and installation tool | FG 33/Set B | WS33.00-P-0064B |
| 210 589 06 21 00 Key programming unit set | FG 82/set B | WS82.00-P-0012B |
| 210 589 06 21 01 Key programming unit | FG 82/set B | WS82.00-P-0012-01B |
| 210 589 06 21 02 Power unit | FG 82/set B | WS82.00-P-0012-02B |
| 210 589 06 21 03 Connection cable | FG 82/set B | WS82.00-P-0012-03B |
| 210 589 06 23 00 Template for right B-pillar | FG 63/Set K | WS63.00-P-0051K |
| 210 589 06 33 00 Removal and installation tool | FG 26/Satz B | WS26.00-P-0077B |
| 210 589 07 21 00 Bracket | FG 46/Set B | WS46.00-P-0070B |
| 210 589 07 23 00 Template for top left section of rear fender | FG 63/64/Set K | WS63.00-P-0056K |
| 210 589 08 21 00 Gage | FG 33/Set A | WS33.00-P-0161A |
| 210 589 08 23 00 Template for top right section of rear fender | FG 63/64/Set K | WS63.00-P-0057K |
| 210 589 08 63 00 145-pin test cable | FG 07/Set B | WS07.00-P-0080B |
| 210 589 09 23 00 Template for front bottom section of left rear fender | FG 63/64/Set K | WS63.00-P-0054K |
| 210 589 10 23 00 Template for front bottom section of right rear fender | FG 63/64/Set K | WS63.00-P-0055K |
| 210 589 10 63 00 Clamping plates | FG 32/Set B | WS32.00-P-0045B |
| 210 589 11 23 00 Gauge for left taillamp cutout | FG 63/64/Set K | WS63.00-P-0052K |
| 210 589 11 63 00 Test cable | FG 91/Set B | WS91.00-P-0025B |
| 210 589 12 23 00 Gauge for right taillamp cutout | FG 63/64/Set K | WS63.00-P-0053K |
| 210 589 13 23 00 Template rear end center assembly | FG 64/Set K | WS64.00-P-0042K |
| 210 589 14 23 00 Template rear end center assembly | FG 64/Set K | WS64.00-P-0043K |
| 210 589 15 23 00 Set of adhesive templates for model designation plate | FG 88/Set K | WS88.00-P-0013K |
| 210 589 16 23 00 Mounts (4 each) | FG 35/Set C | WS35.00-P-0150C |
| 210 589 17 23 00 Side portal frame | FG 60/62/63/64/65/Set K | WS63.00-P-0059K |
| 210 589 18 23 00 Left tail lamp gauge | FG 63/64/Set K | WS63.00-P-0048K |
| 210 589 19 23 00 Right taillamp gauge | FG 63/64/Set K | WS63.00-P-0049K |
| 210 589 22 23 00 Gauge adapter | FG 62/Set K | WS62.00-P-0109K |
| 210 589 23 23 00 Templates | FG 88/Set K | WS88.00-P-0030K |
| 210 589 25 23 00 Model designation mount | FG 88/set K | WS88.00-P-0035K |
| 210 589 26 23 00 Model designation mount | FG 88/set K | WS88.00-P-0036K |
| 210 589 27 23 00 Model designation mount | FG 88/set K | WS88.00-P-0037K |
| 210 589 28 23 00 Model designation mount | FG 88/set K | WS88.00-P-0038K |