Removing and installing front fender - AR88.10-P-1000N

MODEL 215 

Fig 1: Identifying Front Fender Remove/Install Components - Model 215 (1 Of 3)

Fig 2: Identifying Front Fender Remove/Install Components - Model 215 (2 Of 3)

Fig 3: Identifying Front Fender Remove/Install Components - Model 215 (3 Of 3)

	Removal, installation
1	Open engine hood and move to upright position		AR88.40-P-1000M
2	Remove A-pillar paneling		AR88.80-P-8500K
3	Unscrew screws (2)
4	Unscrew screw (5)
5	Remove inner fender in front fender		AR88.10-P-1300M
6	Unscrew screw (6)
7	Pivot retaining bracket (7) to center of vehicle, pull backward and remove
8	Remove foam rubber insert (8) and unscrew screws (9)
9	Press off rocker panel (3) and press downward until nuts (4) are accessible	First remove spreading rivet downward	Figure
10	Unscrew nuts (4)
11	Unhook front fender (1) from mount (11) at front on bumper (10) and remove
12	Install in opposite order	Installation:  Ensure that driver's door and engine hood are correctly positioned, seal should make contact with inner fender

Fig 4: Identifying Installation Wedge (110 589 03 59 00)