Installing two-way radio wiring harness - AN82.71-P-1000-01M

Model 220 

Connection schematic for two-way radio wiring harness (4) 

Fig 1: Identifying Two-Way Radio Wiring Harness

1. Route two-way radio wiring harness (4) from passenger footwell to glove compartment as shown in figure.

   Tie wiring harness to cross tube with cable straps.

   Fig 2: Identifying Two-Way Radio Wiring Harness

   
2. Route tie-out from two-way radio wiring harness (4) to interior socket (X58/1) as shown in figure along present lines to right A-pillar and fasten with cable straps.
   Fig 3: Identifying Two-Way Radio Wiring Harness And Interior Socket

   
3. Route tie-out from two-way radio wiring harness (4) to passenger footwell as shown in figure and connect cockpit wiring harness/frame floor system connector (X18) to frame floor system wiring harness (1).
   Fig 4: Identifying Cockpit Wiring Harness/Frame Floor System Connector And Frame Floor System Wiring Harness

   
4. Mark hole pattern for interior socket (X58/1) in right knee guard as shown in figure and drill 18 mm dia. hole.
5. Install socket in right knee guard.

When installing knee guard it is necessary to connect the interior socket (X58/1).

Fig 5: Identifying Interior Socket And Hole Dimension