Retrofit cell phone - AN82.70-P-0002NN: Notes
MODEL 215 as of 1.7.00 up to 30.6.01 except CODE (852) CTEL preinstallation assembly at dome except CODE (855) TELE AID with CODE (819) 6-disk CD changer
MODEL 215 as of 1.7.00 up to 30.6.01 except CODE (852) CTEL preinstallation assembly at dome except CODE (855) TELE AID with CODE (810) Sound system with CODE (819) 6-disk CD changer
| Removal | |||
| Notes on telephone retrofitting | Models 215, 220 as of 1.7.00 up to 30.6.01. | AH82.70-P-0001-04C | |
| 1 | Connect quiescent current retention device | *WH58.30-Z-1012-09A | |
| Risk of explosion from explosive gas. Risk of poisoning and caustic burns from swallowing battery electrolyte. Risk of injury through burns to skin and eyes from battery acid or when handling damaged leadacid batteries | No fire, sparks, naked flames or smoking. Wear acid-protective gloves, clothing and eye protection. Pour battery electrolyte only into suitable and appropriately marked containers. |
AS54.10-Z-0001-01A | |
| 2 | Disconnect ground cable of battery | ||
| AR54.10-P-0003I | |||
| Battery notes | All types. | AH54.10-P-0001-01A | |
| 3.1 | Remove radio | ||
| AR82.60-P-7502N | |||
| 3.2 | Remove/install operating, display and control module | with COMAND (code 352a) operating and display system | |
| AR82.85-P-7472N | |||
| 4 | Remove rear passenger compartment floor covering | ||
| AR68.20-P-4800N | |||
| 5 | Open left and right wiring ducts | ||
| 6 | Remove armrest with console | ||
| 7 | Remove front seats | ||
| AR91.10-P-1000N | |||
| 8 | Remove rear backrest | ||
| AR91.12-P-1620MA | |||
| 9 | Remove seat adjustment device | ||
| AR91.10-P-1450N | |||
| 10 | Remove parcel shelf | ||
| AR68.30-P-4580M | |||
| 11 | Remove left and right-hand trunk lining | ||
| AR68.30-P-4600M | |||
| Install | |||
| 12 | Install optical waveguide module | ||
| AR82.70-P-0004-01A | |||
| 13 | Retrofit fiber optic wiring harness | AN82.70-P-0002-01NN | |
| 14 | Retrofit wiring harness for Nokia 6150 CTEL | AN82.70-P-0002-03MAM | |
| 15 | Retrofit interface | ||
| AR82.70-P-8920I | |||
| 16.1 | Retrofit antenna for Nokia 6150/GPS CTEL | AN82.62-P-0001-02IA | |
| 17 | Retrofit bracket for Nokia 6150 portable CTEL (telephone) on center console | ||
| AR82.70-P-8918M | |||
| 18 | Install E-net compensator onto parcel shelf | ||
| AR82.70-P-0010AD | |||
| 19.1 | Retrofit handsfree microphone | AN82.70-P-8969-04MA | |
| 20 | Fit remaining parts to vehicle | ||
| 21 | Perform startup and function check |
COMMERCIALLY AVAILABLE TOOLS
| Number | Designation |
|---|---|
| WH58.30-Z-1012-09A | Quiescent current retention unit |
PARTS ORDERING NOTES
| Part no. | Designation | Quantity |
|---|---|---|
| Design Group 82 (see EPC) | Voltage supply wiring harness in center armrest | 1 |
| Design Group 82 (see EPC) | RF cable in center armrest | 1 |
| A220 820 13 35 | Microphone for handsfree system (only if necessary) | 1 |
| Design Group 82 (see EPC) | D2B interface (control module) | 1 |
| Design Group 82 (see EPC) | PT screw for D2B interface (control module) 4x16 mm | 2 |
| Design Group 82 (see EPC) | Wiring harness for Nokia 6150 portable CTEL | 1 |
| Design Group 82 (see EPC) | Compensator (antenna amplifier) | 1 |
| N913 017 004 000 | Nut M4 | 2 |
| Design Group 82 (see EPC) | Bracket for compensator, duplexer, receiver | 1 |
| N914 128 004 200 | Sheet-metal screw for upper bracket to body | 1 |
| Design Group 99 (see EPC) | Parts kit for CTEL in armrest (order according to interior equipment specification) | 1 |
| Design Group 82 (see EPC) | Antenna (only if necessary) | 1 |
| Design Group 82 (see EPC) | Cable fastener (only if necessary) | 1 |
| Design Group 82 (see EPC) | Body-bound rivet (only if necessary) | 1 |
| Design Group 82 (see EPC) | Fiber optic cable module (order with length specification 4650 mm) | 1 |
| Design Group 82 (see EPC) | D2B clutch housing | 1 |