Remove/install front rubber bushing in rear axle mount - AR35.10-P-0040-02I

Fig 1: Identifying Extraction Tool (220 589 02 43 00)

Fig 2: Identifying Insertion Tool (140 589 04 33 00)

Remove rubber mount 

Always replace both front rubber mounts.

1. Cut off protruding rubber bead (arrow) on rubber mount (1a) using suitable knife (wear safety glasses and safety gloves).

   

   Bead must be cut off so that rubber mount is not sheared off when it is pushed out. Otherwise, this causes the pressure piece to become jammed in the rear axle carrier.

   Fig 3: Locating Rubber Mount

   
2. Place extraction tool (01a, 01d) on rear axle carrier.
3. Push rubber mount (1a) out of rear axle carrier.
   Fig 4: Identifying Extraction Tool And Rubber Mount

   

   Install rubber mount 

   Pay attention to installation position. The arrows on the underside of the rubber mount must point in the direction of travel.

   Fig 5: Locating Mount Travel Direction Point

   
4. Grease rubber mount (1a) around circumference with lubricant.
5. Place insertion tool (01b, 01c) on rear axle carrier.

   

   Arrows on insertion tool must point in direction of travel.

6. Insert rubber mount (1a) into rear axle carrier.
   Fig 6: Identifying Rubber Mount And Insertion Tool