Removing and installing complete rear axle - AR35.10-P-0010MB

MODELS 220.175 /178 with CODE (Z04) Light armoring with CODE (Z07) Maximum protection 

Fig 1: Identifying Complete Rear Axle Remove/Install Components - Model 220.175/178

Illustrated for code Z07 

Fig. item, etc.	Work instructions
	The removal of the rear axle corresponds to production vehicles except for the modifications listed below	Refer to: ↓
		Removing and installing complete rear axle	AR35.10-P-0010I
	Risk of injury  with trapped or crushed limbs  when working on springs or spring-loaded components.	Use only approved tensioning devices; additionally shield off hazardous area if necessary.	AS00.00-Z-0001-01A
		Check special tools for damage and correct operation, (visual inspection). Wear protective gloves.
73	Rear spring	Tension on left and right, for Code Z07 only.	AR32.20-P-0200-06MB
		Spring compressor	Fig 2
		Clamping plates	Fig 3
1c	front rear axle mount
Arrow	Stop plate	Install components in correct positions.
1	Rear axle	Use pit lift or floor jack under rear axle center assembly for support. The assembly adapter specified for production vehicles must not be used.
	Bleed brake system	for Code Z07 only Modified work procedure due to brake booster hydraulic unit	AR42.10-P-0010MB
	Check vehicle level at front and rear axle with electronic inclination meter and adjust, if necessary	for Code Z04	AR40.20-P-0301I
		for Code Z07	AR40.20-P-0301MB

Fig 2: Identifying Spring Compressor (202 589 01 31 00)

Fig 3: Identifying Clamping Plates (202 589 13 63 00)