Press out and attach track rod joint at wheel carrier - AR35.20-P-0109-01I

TORQUE SPECIFICATION

TIE ROD

Number	Designation				Model 215	Model 220
BA35.20-P-1002-04A	Self-locking nut, tie rod at wheel carrier	yellow M10x1		Nm	-	-
		silver or blue M10x1		Nm	-	-
		silver or blue M10x1.5	Stage 1	Nm	30	30
		silver or blue M10x1.5	Stage 2	∠°	-	-

Fig 1: Identifying Thrust Washer M 10X1.5 (210 589 04 63 00)

G04845405

Fig 2: Identifying Puller (140 589 00 33 00)

G04845406

Pushing off

Detach self-locking nut from tie rod joint (4c).
Remove cable holder.
Mount thrust piece (098).
Press off tie rod joint (4c) using puller (097).
Do not damage the rubber boot when pressing off.
Remove puller (097 ) and thrust piece (098).
Clean tapered connection.
Replace cable holder.
Replace self-locking nut and tighten with .
If necessary, counterhold ball head using Allen wrench.

Fig 3: Identifying Rod Joint And Thrust Piece