Remove and install cover on rear seat cushion - AR91.18-P-1850MA

MODEL 220.0 /1 except CODE (223b) Electrically adjustable rear bench seat except CODE (224c) Electrically adjustable rear single seats, with seat ventilation, seat heater and memory package except CODE (248) rear seat with integral child seat 

Fig 1: Identifying Cover On Rear Seat Cushion Remove/Install Components - Model 220.0 /1 (1 Of 2)

Fig 2: Identifying Cover On Rear Seat Cushion Remove/Install Components - Model 220.0 /1 (2 Of 2)

	Remove/Install
1	Remove rear seat cushion (1).	Place rear seat cushion (1) with the covering (7) downwards on a suitable base.	AR91.12-P-1020MA
2	Press down cushion frame (3), pull out covering (7) from insert fold (arrows) and unhook at the hook-in tongues	Installation:  Insert the retaining clamps (4) distributed in the insert fold.
3	Remove cushion frame (3) from the foam padding (2)
4	Turn round covering (7) on the outside of the foam padding (2)
5	Detach stapling clips (5) from the outside inwards, removing the covering (7) in pieces from the foam padding (2)	Installation:  Insert stapling wire (6) in the stapling clips (6) using the press-in tool.
	Installation tool for retaining wire		WF58.50-P-9118-02A
6	Remove covering (7) from the foam padding (2)
7.1	Pull stapling wire (6) out of the foam sleeves on the covering (7)	Only when replacing the covering. Insert and align stapling wires (6) in fabric sleeves
8	Install in the reverse order