Remove/install extinguishing agent tank - AR86.10-P-0100MB

MODEL 220.1 /8 with CODE (Z04) Light armoring with CODE (Z07) Top protection with fire extinguishing system

Fig 1: Identifying Extinguishing Agent Tank Remove/Install Components

MODIFICATION NOTES

8.5.07

"Transportation of filled extinguishing agent tanks is only allowed without squibs and with squib opening sealed", added

OS86.10-P-1000-02A

	Remove/install
	Special notice regarding wax preservative		AH97.20-P-1000-02PV
	Notes on aerosol extinguishing agent tank		AH86.10-P-0001-02A
	Notes for extinguishing agent tank pressure monitor switch		AH86.10-P-0001-03A
1	Switch off ignition, detach transmitter key from electronic ignition switch control unit
2	Remove fuses no. 54 and no. 58 in rear fuse and relay module	The rear fuse and relay module is located below the right rear seat. See: ↓
		Fuse assignment of rear fuse and relay box	GF54.15-P-1256-01MB
3	Remove paneling from extinguishing agent tank (1).		AR86.10-P-0103MB
4	Disconnect electric lead from squib (7).	To avoid triggering the fire extinguishing system ensure that, as first operation step, the electrical line is disconnected from the squib (7) when removing the extinguishing agent tank (1).
5	Disconnect fire extinguishing tank 1 pressure monitor connector (S62/27x1) and fire extinguishing tank 2 pressure monitor connector (S62/28x1)	Do not remove extinguishing agent tank pressure monitoring switch 1 (S62/27) or extinguishing agent tank pressure monitoring switch 2 (S62/28) from extinguishing agent tank (1), otherwise the extinguishing agent tank (1) can be drained.
6	Unscrew union nuts (6) and remove extinguishing agent tubing (5)
7	Loosen clamps (2) and remove extinguishing agent tank (1).
8	Check weight of extinguishing agent tank (1).	Always check weight before installing to prevent installing any extinguishing agent tank (1) with insufficient quantity of extinguishing agent.
		Each extinguishing agent tank (1) should have an additional weight of 60 g as indicated. If the gross weight is less than 50 g, replace extinguishing agent tank (1). An approximately 5 mm long indicator (3) is visible and can be felt on the front of the connector (4) when the extinguishing agent tank (1) is empty. If the extinguishing agent tank (1) is replaced, dispose of old unit properly. Refer to: ↓
		Notes on disposing aerosol extinguishing agent tank	OS86.10-P-1000-02A
9	Install in the reverse order
10	Perform self-test for fire extinguishing system		AR86.10-P-0101-01MB