Adjust front door - AR72.10-P-0550M
MODEL 220
Fig 1: Identifying Front Door Contour To Front Fender, Contour To Rear Fender And Contour To A-Pillar And Roof Paneling
| Inspect, set | |||
| 1 | Remove striker eye | ||
| 2 | Inspect sizes of gaps at door all round | Figure | |
| AR60.00-P-0700-01M *BE60.00-P-1002-01A |
|||
| 3 | Loosen bolts (5) from A-pillar and adjust gap dimension by moving front door | Loosen bolts (5) only until it is possible to move the front door |
*BA72.10-P-1001-01E |
| 4 | Loosen bolts (3) from inner door panel and adjust driver's door contour on hinge side by moving front door. | *BA72.10-P-1002-01E | |
| 5 | Install striker eye (7) | ||
| 6 | Completely close front door and adjust contour on striker eye by moving striker eye (7) | ||
| 7 | Tighten bolts (8) on striker eye (7) | *BA72.10-P-1006-01E | |
| 8 | Check contour and fit at window frame (C) in relation to roof paneling and front wall pillar, adjust if possible | ||
| 9 | Check door for easy motion |
TEST AND ADJUSTMENT VALUES, GAP DIMENSIONS AT HOODS, DOORS AND COVERS
| Number | Designation | Model 220.0/1 | |||
|---|---|---|---|---|---|
| BE60.00-P-1002-01A | Gap dimension | Front door to A-pillar | Dimension "B" | mm | 8.0 (± 0.5) |
| Front door to fender | Dimension "H" | mm | 5.0 (± 0.5) | ||
| Front door to rear door | Dimension "I" | mm | 5.0 (± 0.5) | ||
| Front door to roof | Dimension "C" | mm | 5.0 (± 0.5) | ||
| Rear door to upper side section | Dimension "D" | mm | 5.0 (± 0.5) | ||
| Rear door to lower side section | Dimension "J" | mm | 5.0 (± 0.5) | ||
| Fender to A-pillar | Dimension "Q" | mm | - | ||
| Front door to rear fender | Dimension "P" | mm | - | ||
| Fig., see | AR60.00-P-0700-01M | ||||
| Number | Designation | Model 220 | |
|---|---|---|---|
| BA72.10-P-1001-01E | Bolt, door hinge to A-pillar | Nm | 35 |
| BA72.10-P-1002-01E | Bolt, door hinge to inner door panel | Nm | 35 |
| BA72.10-P-1006-01E | Bolt to striker eye | Nm | 25 |
Special tools