Remove/install headliner - AR68.30-P-4300M
Models 220.0 /1
Illustrated on model 220.1 with code (414a) Electric glass sliding/pop-up roof
Illustrated on model 220.1 with code (414a) Electric glass sliding/pop-up roof
| Remove/install | |||
|---|---|---|---|
| 1.1 | Open sliding/pop-up roof panel | On vehicles with code (414a) Electric glass sliding/pop-up roof | |
| 2.1 | Remove right front door | Model 220.0 | AR72.10-P-0500M |
| 3 | Remove paneling from left and right A-pillar | AR68.30-P-4050M | |
| 4 | Remove paneling from left and right B-pillar | AR68.30-P-4700M | |
| 5 | Remove paneling from left and right C-pillar | AR68.30-P-4490M | |
| 6 | Remove edge guard from door cutouts | ||
| 7.1 | Remove PTS warning display rear dome lamp | On vehicles with code (220a) Parktronic system (PTS) |
|
| 8.1 | Remove infrared interior monitoring transmitter/ receiver | On vehicles with code (882b) Infrared interior monitoring (only with ATA) | AR80.50-P-9820F |
| 9 | Remove left and right dome lamp in rear | AR82.20-P-0113M | |
| 10 | Remove rear and front handles | ||
| 11 | Remove sun visors | ||
| 12 | Remove front interior lights | ||
| 13 | Remove overhead control panel control module | AR82.20-P-1000M | |
| 14 | Remove inside rearview mirror | AR68.40-P-0001M | |
| 15 | Disconnect rain sensor connector | ||
| 16.1 | Remove rail (5) from sliding roof cutout upward (arrows) | On vehicles with code (414a) Electric glass sliding/pop-up roof | |
| 17 | Remove driver seat | AR91.10-P-1000M | |
| 18 | Remove rear shelf | AR68.30-P-4580M | |
| 19 | Disconnect electrical connectors (3) on right below rear shelf | ||
| 20 | Loosen headliner (1) in rear area from Velcro strips (4) | ||
| 21 | Unhook headliner (1) from clips (1) in rear area (2) | ||
| 22 | Slightly pull headliner (1) down in area of windshield | ||
| 23.1 | Press headliner (1) with mounting rail toward front (arrows) out of sliding/pop-up roof frame guide (7) | On vehicles with code (414a) Electric glass sliding/pop-up roof | |
| 24 | Completely move passenger seat downward and lay backrest down | ||
| 25.1 | Remove headliner (1) through passenger door | Model 220.0 | |
| 25.2 | Remove headliner (1) through rear door | Model 220.1 | |
| 26.1 | Prepare headliner (1) for installation. | Only when replacing headliner (1). | AR68.30-P-4305M |
| 27 | Install in the reverse order | ||
| 28 | Perform function check |