Removing and installing washing water reservoir - AR82.35-P-6000M

MODEL 215, 220 

Illustrated on model 220 

Fig 1: Identifying Washing Water Reservoir Remove/Install Components (Model 220)

	Removal, installation
1	Open engine hood and move to upright position		AR88.40-P-1000M
2	Remove washing water heater hoses (1) on washing water reservoir (4)
3	Unscrew nuts (2) and lift coolant expansion reservoir (3) up and lay down to side
	Danger  of severe burns to skin and eyes from hot coolant spewing out. Coolant is toxic  when swallowed	Open cooling system only when coolant temperature is below 90°C Open cover slowly and reduce pressure Do not fill beverage containers with coolant Wear protective gloves, protective clothing and protective goggles	AS20.00-Z-0001-01A
4	Unclip electrical connector (5) from coolant expansion reservoir (3) and place coolant expansion reservoir (3) to side
5	Unclip electrical connector (6) from washing water reservoir (4)
6	Pull windshield washer pump (M5/1) and headlamp washer pump (M5/2) up completely out of washing water reservoir (4) together with outlet hoses and electrical connections	Catch washing water
7	Remove washing water reservoir (4) upward
8	Install in opposite order
9	Fill windshield washer reservoir	For mixing ration see table on package MB windshield washer concentrate according to service product specifications sheet 371.
10	Check pumps for proper function