Retrofit portable CTEL holder of hands-free system - AZ82.70-P-0005-01M

Align base holder (2) on console (12), mark holes and drill with 3mm dia. bit.
Screw base holder onto side of telephone with the 3 sheet metal screws (3) included

Fig 1: Identifying Base Holder, Console And Sheet Metal Screws
Insert portable cellular telephone holder (1) into base holder (2).
Hook connection lead below console (12) with coil of spiral lever as shown in figure (arrow) and arrest from inside with adhesive felt.

Fig 2: Identifying Portable Cellular Telephone Holder And Base Holder
Route connector (8) into radio shaft.

Fig 3: Identifying Radio Shaft Connector