Remove/install rear rubber mount for center assembly mount in rear axle carrier - AR35.10-P-0050I: Notes

MODELS 215.373 /374 /375 /376 /378 /379, 220.025 /026 /028 /063 /065 /067 /070 /073 /074 /075 /083 /084 /087 /126 /128 /165 /167 /170 /173 /174 /175 /176 /178 /179 /183 /184 /187 

Shown on model 220 with Airmatic 

Fig 1: Identifying Rear Rubber Mount For Center Assembly Mount Remove/Install Components - Shown On Model 220

	Remove/Install
	While working on the rear axle care must be taken to ensure that the surface of all aluminum components do not get any scratches, cracks and notches. Otherwise the service life of the parts will be affected
1	Remove rear axle center assembly (50)	with RA center piece, 198, 210 mm dia.	AR35.31-P-0520I
		with RA center piece, 240 mm dia.	AR35.31-P-0520IA
		Only models 215.379 and 220.179.	AR35.31-P-0520IM
2.1	Slacken bracket for damping valve unit line on rear axle carrier and swivel down.	Model 220 with Airmatic (semi-active air suspension), code 489a, when removing the left rubber mount.
3	Remove/install rear rubber mounts for rear axle center assembly suspension (62)		AR35.10-P-0050-02I
		Extraction and insertion tool	Figure
4	Install in the reverse order

Fig 2: Identifying Extraction And Installation Tool (210 589 02 43 00)