Remove/install antenna - AR82.70-P-8951I

MODEL 220 

Telephone/GPS antenna on rear window 

Fig 1: Identifying Antenna Remove/Install Components (Model 220)

	Remove/install
	Information on preventing damage to electronic components due to electrostatic discharge		AH54.00-P-0001-01A
1	Detach roof antenna for telephone and GPS (A2/49) from rear window using preheated spatula	Do not damage rear window.
2	Remove roof antenna and remove adhesive pad on bottom side of antenna	Installation:  Remove adhesive residues on antenna and glue a new adhesive pad onto bottom side of antenna. When gluing on the antenna, make sure that after removing the protective foil on the adhesive pad, it is stuck to the rear window immediately. Once positioned, apply approx. 20 kg pressure to the antenna for approx. 5 seconds
3	Remove adhesive residues on rear window using window cleaning agent		*BR00.45-Z-1025-04A
		Installation:  Apply glass primer to bonding surface on rear window	*BR00.45-Z-1023-02A
4	Remove coverings in trunk	Model 220.0/1	AR68.30-P-4600M
		Model 220.8	AR68.30-P-4600MP
		Right side trim panel
5	Disconnect connectors (1)
6	Remove lines (2) with rubber grommet (3) to cable duct (4)	Note installation of lines in luggage compartment Installation: Coat rubber grommet with soapy water
7	Remove ornamental frame (5a, 5b) on rear wall window	Ornamental frame at right and below	AR67.20-P-2200M
8	Remove lines from ornamental frame	Installation:  Use suitable tool to insert lines into the trim strip rubber section
9	Install in the reverse order