Remove, install rear rubber mount of rear axle center assembly suspension - AR35.10-P-0050-02P

Fig 1: Identifying Extraction And Installation Tool (210 589 02 43 00)

Remove rubber mounts 

1. Measure and note down press-in depth of inner core of both rubber mounts (62) to rear axle crossmember from front using depth gauge.
   Fig 2: Identifying Rubber Mounts

   
2. Use sleeve, Component 15 (062l), thrust plate, Component 16 (062q) and bolt (116 mm in length) to press both rubber bushings forward for removal from the transverse differential support bracket.
   Fig 3: Identifying Rubber Mount, Sleeve Part And Thrust Piece Part

   

Install rubber mount 

3. Working from the front, position the rubber bushing (62) on the transverse differential support bracket with the end cover on the final-drive unit toward the front.

   Front view 

   Fig 4: Identifying Rubber Bushing

   
4. Use insertion tool, component 07 (062p), sleeve, component 15 (062l) and bolt (116 mm in length) with nut to pull both rubber bushings (62) into the transverse differential support bracket, continuing until you obtain the previously measured insertion depth.
   Fig 5: Identifying Rubber Mount, Sleeve Part And Thrust Piece Part

   
5. Check insertion depth of the rubber bushings (62) and correct as required.

   Repeat step  3 if the insertion depth is incorrect.

   Fig 6: Identifying Rubber Busings