Gasoline injection and ignition system (ME-SFI ) - Diagnosis - Diagnostic trouble code memory (Fault Code P0100, P0105, P0110, P0115, P0120, P0130, P0133, P0135, P0136, P0140, P0141, P0150, P0153, P0155, P0156, P0160, P0161, P0170, P0173, P0201, P0202, P0203, P0204, P0205, P0206) - AD07.61-P-4000A
ENGINES 112.910,
112.911 up to 31.5.00,
112.920,
112.921 up to 31.5.00,
112.923,
112.940 /941 /942 up to 31.5.00,
112.943
Fault codes from P0000 to P0299
| Hazard from contact with parts conducting high voltages. | Do not touch parts which conduct high voltages. Persons who wear electronic implants (e.g. heart pacemakers) must not carry out work on the ignition system. | AS15.10-Z-0001-01A | |
| Lethal hazard from being drawn into rotating vehicle parts | Do not reach into rotating parts. Wear closed and close-fitting work clothes. Secure area of rotating vehicle components against unauthorized access. |
AS00.00-Z-0004-01A | |
| Risk of explosion from fuel igniting, risk of poisoning from inhaling and swallowing fuel as well as risk of injury to eyes and skin from contact with fuel. | No fire, sparks, naked flames or smoking. Pour fuels only into suitable and appropriately marked containers. Wear protective clothing when handling fuel. |
AS47.00-Z-0001-01A | |
| Notes on avoiding damage to the ignition system | Engines 104, 111, 112, 113, 119, 120 with ME-SFI fuel injection and ignition system | AH15.10-P-0002-01D | |
| The fault code cannot be read out with the pulse counter | |||
| ■ Symbol for USA vehicles for activation of the malfunction indicator lamp CHECK ENGINE • Symbol for EURO3 vehicles for activation of the engine diagnosis malfunction indicator lamp (is indicated in the HHT as ■) The malfunction indicator lamp does not go on until a fault relevant for the exhaust system was stored during the last driving cycle (exception misfire "damaging to TWC", malfunction indicator lamp goes on immediately). |
|||
| Ignition: On | |||
| Connect hand-held-tester (HHT), read out diagnostic trouble code memory | AD00.00-P-2000-03A | ||
Gasoline injection and ignition system (ME-SFI )
|
AD07.61-P-2000A | ||
| Check and adjust engine | Engine diagnosis manual | ||
| Diagnostic trouble code memory | |||
| Fault code |
Possible cause | Note | Remedy |
| No fault code | No fault detected | Depending on the complaint, carry out testing of ME-SFI electrical system in full | AD07.61-P-6000A |
| AD07.61-P-6001A | |||
| 112.942 in MODEL 163.154 up to 31.5.98 | AD07.61-P-6002A | ||
| AD07.61-P-6003A | |||
| AD07.61-P-6004C | |||
| P0100 ■ • | Hot-film mass air flow sensor (B2/5) | AD07.61-P-6000-04A | |
| Hot film mass air flow sensor, fault code description ME-SFI | AD07.61-P-4000-01A | ||
| P0105 ■ | Pressure sensor (B28) | AD07.61-P-6000-06A | |
| Pressure sensor, fault code description ME-SFI | AD07.61-P-4000-02A | ||
| P0110 ■ • | Intake air temperature sensor (in the hot film mass air flow sensor B2/5) | AD07.61-P-6000-05A | |
| Intake air temperature sensor, fault code description ME-SFI | AD07.61-P-4000-03A | ||
| P0115 ■ • | Coolant temperature sensor (B11/4) | AD07.61-P-6000-08A | |
| Coolant temperature sensor, fault code description ME-SFI | AD07.61-P-4000-04A | ||
| P0120 | Actual value potentiometer in the throttle valve actuator (M16/6) | AD07.61-P-6002-03A | |
| Actual value potentiometer in the throttle valve actuator, fault code description ME-SFI | AD07.61-P-4000-48A | ||
| P0130 ■ • | A Oxygen sensor on right upstream of TWC (G3/4) | AD07.61-P-6000-11A | |
| B Oxygen sensor on right upstream of TWC (G3/4) voltage increase too small | |||
| Oxygen sensor signal, fault code description ME-SFI | AD07.61-P-4000-06A | ||
| P0133 ■ • | A Oxygen sensor on right upstream of TWC (G3/4) aging correction variable exceeded | AD07.61-P-6000-11A | |
| B Oxygen sensor on right upstream of TWC (G3/4) aging of cycle duration too long | |||
| C Oxygen sensor on right upstream of TWC (G3/4) aging of Oxygen sensor too slow | |||
| Aging of oxygen sensor upstream of TWC, fault code description ME-SFI | AD07.61-P-4000-07A | ||
| P0135 ■ • | Oxygen sensor heating of O sensor on right upstream of TWC (G3/4) | AD07.61-P-6000-13A | |
| Oxygen sensor heating, fault code description ME-SFI | AD07.61-P-4000-08A | ||
| P0136 ■ • | Oxygen sensor on right downstream of TWC (G3/6) | AD07.61-P-6000-15A | |
| Oxygen sensor signal, fault code description ME-SFI | AD07.61-P-4000-06A | ||
| P0140 ■ • | Oxygen sensor on right upstream of TWC (G3/4) | AD07.61-P-6000-11A | |
| Oxygen sensor signal, fault code description ME-SFI | AD07.61-P-4000-06A | ||
| P0141 ■ • | Oxygen sensor heating of Oxygen sensor on right downstream of TWC (G3/6) | AD07.61-P-6000-17A | |
| Oxygen sensor heating, fault code description ME-SFI | AD07.61-P-4000-08A | ||
| P0150 ■ • | A Oxygen sensor on left upstream of TWC (G3/3) | AD07.61-P-6000-10A | |
| B Oxygen sensor on left upstream of TWC (G3/3) voltage increase too small | |||
| Oxygen sensor signal, fault code description ME-SFI | AD07.61-P-4000-06A | ||
| P0153 ■ • | A Oxygen sensor on left upstream of TWC (G3/3) aging of correction variable exceeded | AD07.61-P-6000-10A | |
| B Oxygen sensor on left upstream of TWC (G3/3) aging of cycle duration too long | |||
| C Oxygen sensor on left upstream of TWC (G3/3) aging of Oxygen sensor too slow | |||
| Aging of oxygen sensor upstream of TWC, fault code description ME-SFI | AD07.61-P-4000-07A | ||
| P0155 ■ • | Oxygen sensor heating of Oxygen sensor on left upstream of TWC (G3/3) | AD07.61-P-6000-12A | |
| Oxygen sensor heating, fault code description ME-SFI | AD07.61-P-4000-08A | ||
| P0156 ■ • | Oxygen sensor on left downstream of TWC (G3/5) | AD07.61-P-6000-14A | |
| Oxygen sensor signal, fault code description ME-SFI | AD07.61-P-4000-06A | ||
| P0160 ■ • | Oxygen sensor on left downstream of TWC (G3/5) | AD07.61-P-6000-14A | |
| Oxygen sensor signal, fault code description ME-SFI | AD07.61-P-4000-06A | ||
| P0161 ■ • | Oxygen sensor heating of Oxygen sensor on left downstream of TWC (G3/5) | AD07.61-P-6000-16A | |
| Oxygen sensor heating, fault code description ME-SFI | AD07.61-P-4000-08A | ||
| P0170 ■ • | A Self-adaptation of the "partial load" mixture formation for right cylinder bank to limit value of ME-SFI control module (N3/10) | Air leak, fuel injectors of diaphragm-type pressure regulating valve, wear to engine | |
| A Self-adaptation of the "idle" mixture formation for right cylinder bank to limit value of ME-SFI control module (N3/10) | |||
| Self-adaptation of mixture formation to limit, fault code description ME-SFI | AD07.61-P-4000-09A | ||
| P0173 ■ • | A Self-adaptation of the "partial load" mixture formation for left cylinder bank to limit value of ME-SFI control module (N3/10) | Air leak, fuel injectors of diaphragm-type pressure regulating valve, wear to engine | |
| B Self-adaptation of the "idle" mixture formation for left cylinder bank to limit value of ME-SFI control module (N3/10) | |||
| Self-adaptation of mixture formation to limit, fault code description ME-SFI | AD07.61-P-4000-09A | ||
| P0201 ■ • | Fuel injector (Y62y1) cylinder 1 | AD07.61-P-6000-18A | |
| Fuel injectors, fault code description ME-SFI | AD07.61-P-4000-10A | ||
| P0202 ■ • | Fuel injector (Y62y2) cylinder 2 | AD07.61-P-6000-19A | |
| Fuel injectors, fault code description ME-SFI | AD07.61-P-4000-10A | ||
| P0203 ■ • | Fuel injector (Y62y3) cylinder 3 | AD07.61-P-6000-20A | |
| Fuel injectors, fault code description ME-SFI | AD07.61-P-4000-10A | ||
| P0204 ■ • | Fuel injector (Y62y4) cylinder 4 | AD07.61-P-6000-21A | |
| Fuel injectors, fault code description ME-SFI | AD07.61-P-4000-10A | ||
| P0205 ■ • | Fuel injector (Y62y5) cylinder 5 | AD07.61-P-6000-22A | |
| Fuel injectors, fault code description ME-SFI | AD07.61-P-4000-10A | ||
| P0206 ■ • | Fuel injector (Y62y6) cylinder 6 | AD07.61-P-6000-23A | |
| Fuel injectors, fault code description ME-SFI | AD07.61-P-4000-10A |