Remove/install front brake control cable - AR42.20-P-0520P
MODEL 203, 209
Shown on model 203
MODIFICATION NOTES
| 12.12.02 | Check version of pedal assembly, added | Step 12 | BT42.20-P-0510-01A |
| Remove/install | |||
| Risk of death caused by vehicle slipping or toppling off of the lifting platform. | Align vehicle between the columns of the lifting platform and position the four support plates at the lifting platform support points specified by the vehicle manufacturer. | AS00.00-Z-0010-01A | |
| 1 | Raise vehicle with lifting platform | AR00.60-P-1000P | |
| 2 | Remove cover panel under rear seat cushion | ||
| 3 | Loosen adjusting nut (89) | ||
| 4 | Unhook brake cable (85) at the intermediate lever (91) and detach from the intermediate lever housing using the unclipping device (043) | Figure | |
| 5 | Remove front left floor covering | AR68.20-P-2050P | |
| 6 | Remove cover below instrument panel | AR68.10-P-1500P | |
| 7 | Remove cover (71a) of the parking brake pedal (75) | ||
| 8 | Detach brake cable (85) from parking brake pedal (75) | Figure | |
| 9 | Remove heat shield of exhaust system | ||
| 10 | Unclip and pull out brake cable (85) | ||
| 11 | Install in the reverse order | ||
| Checking | |||
| 12 | Check version of pedal assembly | ||
| Parking brake pedal assembly modified | BT42.20-P-0510-01A | ||
| 13 | Adjust parking brake | AR42.20-P-0540A |