Disconnect Procedures
NOTE:
Numbers and letters in parenthesis refer to numbers and letters in illustrations.
- On vehicles not equipped with TELE AID, go to step 5 . Vehicles equipped with TELE AID, switch TELE AID into service mode by turning ignition ON.
- Turn ON telephone and enter code "*#4610#" on handset.
- Confirm that "No Telematics Service" appears on handset with okay.
- Turn OFF handset.
- Turn OFF ignition.
- Open hood and open snap fasteners (1) on dust filter housing. See Fig 1 .
- Remove dust filter housing (2) exposing battery.
- On vehicles equipped with TELE AID, remove luggage compartment cargo anchoring lugs and remove floor paneling.
- Remove screws (1). See Fig 2 .
- Dismantle cover from TELE AID control module (A35/8).
- Disconnect connection coupling for back up battery and remove back up battery.
- Disconnect negative battery cable (1) and insulate terminal. See Fig 3 .