Retrofitting CD changer in trunk - AZ82.64-P-0001-05F

Model 170 as of 1.7.98 except code 351 in combination with Audio 10 or Audio 30 radio 

1. Screw CD player with changer (A2/6) to mount (20) with 4 short screws (21).

   The maximum length of the mounting screws (21) is indicated on the CD player housing.

2. Install base plate (26) in trunk according to enclosed instructions.
   Fig 1: Identifying Mounting Screws And CD Player Housing

   
3. Connect fiber optic cable D2B (22) and power supply (23).
   Fig 2: Identifying Fiber Optic Cable And Power Supply

   
4. Insert fiber optic cable (2) into reversal loop below CD player with changer (A2/6) as shown in figure.
   Fig 3: Identifying Fiber Optic Cable

   
5. Install mount (20) and CD player with changer (A2/6) in trunk on right with mounting screws (24) as shown in figure.

   Do not kink or stretch fiber optic cable! 

   Routing radii must be greater than 25 mm!

   Fig 4: Identifying Mount And CD Player With Changer In Trunk On Right With Mounting Screws