Retrofitting TrafficStar GPS antenna on instrument panel - AZ82.61-P-0001-01C

Models 170, 202 

GPS antenna on instrument panel illustrated on model 202 

Fig 1: GPS Antenna On Instrument Panel Illustrated - Model 202

1. Fasten GPS antenna (2) with double-sided tape to center of instrument panel (arched surface pointing toward front of vehicle).
   Fig 2: GPS Antenna With Double-Sided Tape To Center Of Instrument Panel - Model 202

   
   Fig 3: GPS Antenna With Double-Sided Tape To Center Of Instrument Panel - Model 170

   
2. Slide antenna lead (3) between windshield and instrument panel with plastic wedge and route along left A-pillar below instrument panel to radio shaft.

   Tie back excessive length below instrument panel.

   Fig 4: Identifying Windshield And Instrument Panel With Plastic Wedge

   
3. Insert TxD data line (ws) into chamber 16 and RxD data lead (bl) into chamber 15 of connector housing (C3) from parts set.
   Fig 5: Inserting Txd Data Line (WS) Into Chamber

   
4. Solder brown wire (br) from GPS antenna to lead for radio connector (A) chamber 8 and insulate.
5. Solder black wire (bk) from GPS antenna to lead for radio connector (A) chamber 7 and insulate.
   Fig 6: Identifying Radio Connector