Converting rear bumper - AZ88.00-P-0001-03I

Preparation 

1. Remove standard bumper.

Assembly 

2. Install inner carrier, impact damper and antennas.
3. Press retaining lugs (B) into anchoring at top and bottom
4. Anchor side support plates in exterior surface using spreading rivets.
5. Rivet side sliding arrests in exterior surface.
6. Press radio antenna into lugs intended for this purpose and fasten with glue.
7. Install spacer strip on stay intended for this purpose.
8. Install bumper.
   Fig 1: Identifying Retaining Lugs