Converting rear bumper - AZ88.00-P-0001-03H

Preparation 

1. Remove standard bumper.
2. Disassemble standard bumper
3. Remove side sliding arrests by drilling out pop rivets (A).
4. Remove side support plates by removing spreading rivets.
   Fig 1: Identifying Pop Rivets

   
5. Remove inner carrier, impact damper and antennas: Press retaining lugs (B) for exterior surface out of anchoring with a screwdriver, remove radio antenna.
6. Remove spacer strip (spare wheel recess)

Assembly 

7. Install inner carrier, impact damper and antennas.
8. Press retaining lugs (B) into anchoring at top and bottom
9. Anchor side support plates in exterior surface using spreading rivets.
10. Rivet side sliding arrests in exterior surface.
11. Press radio antenna into lugs intended for this purpose and fasten with glue.
12. Install spacer strip on stay intended for this purpose.
13. Install bumper.
    Fig 2: Identifying Retaining Lugs