Converting front bumper - AZ88.00-P-0001-02H

Preparation 

1. Remove standard bumper.
2. Disassemble standard bumper
3. Unscrew headlamps from inner carrier.
4. Remove side sliding arrests by drilling out pop rivets (A).
5. Remove side support panels by removing spreading rivets.
   Fig 1: Identifying Pop Rivets

   
6. Remove inner carrier and impact damper Press retaining lugs (B) for exterior surface out of anchoring with screwdriver.

Assembly 

7. Install inner carrier and impact damper
8. Press retaining lugs (B) into anchoring at top and bottom
9. Anchor side support plates in exterior surface using spreading rivets.
   Fig 2: Identifying Retaining Lugs

   
10. Rivet inner side member included with parts kit to exterior surface with pop rivets (A).
    Fig 3: Identifying Pop Rivets

    
11. Hook center grill in front apron and fasten with screws included (arrows).
12. Insert outer grills.
    Fig 4: Identifying Center Grill Screws

    
13. Install headlamp:
    • Fasten headlamp mount to original mounting points (C).
    • Fasten headlamp to mount (D) and to lug (E).
    • Insert adapter cable into headlamp.
14. Install bumper.
    Fig 5: Identifying Headlamp Mounting Points, Mount And Lug