Retrofitting software download - AN82.61-P-1000-03A

Models 129, 140, 168, 202, 208, 210 

Perform software download with auto-pilot system (APS) of 3rd generation with software status Q4. 

1. Remove navigation CD and insert download CD into CD drive.
2. Switch off control module.
3. Switch on unit after a waiting time of at least 5 seconds by simultaneously pressing SC and FM/AM buttons. The menu "SW download for CD" appears with menu points "Interrupt", "Start control module" and, when Telematic box (TMC box) is connected, "Start TMC box". Select "Start control module" or "Start TMC box" with right knob. The date or the version of the software currently loaded and the software on the CD appear on the display.
4. Start the download operation by pressing the right knob. During downloading progress is indicated by a beam diagram. Simultaneously the code LED flashes on the download control module. An error is indicated by a dot code on the display. The download starts again.
5. When the download is completed (15 minutes) the display switches off for a short time. When switched on again the download result is indicated.

   

   Do not start vehicle during download, do not cause other voltage drops in the vehicle electrical system (e.g. switching on other equipment), do not remove CD and do not switch off unit! (Unit will be destroyed!). 

   

   • If a malfunction occurs in the download control module  the download procedure is automatically started again or is terminated if the old software is not yet erased. The display may remain dark.
   • If a malfunction occurs in the TMC box download  the procedure does not  start again by itself. The SW version "00.00" is displayed. The control module must be switched off for approx. 30 seconds before a new download can be started.