Airbag (AB) prerequisites for testing electrical system - AD91.60-P-2000-01A

Test cable for ignition squib connectors 

Material:

1 coupling, part no. 019 545 19 28

1 coupling, part no. 034 545 63 28

2 cables with 2.5 mm sockets from electrical connection set.

2 cables with 2.5 mm pins from electrical connection set.

All connectors or plug-in connectors (red) of the ignition squibs are to be designed with short-circuit bridges. When disconnected, the ignition circuit or the squib is short-circuited. All work on the airbag and ETR restraint system can therefore be carried out with the ignition key removed.

Accessories (for vehicles with automatic child seat recognition - ACSR only) 

MB Babysafe child seat

During welding work, the negative terminal of the battery should also be disconnected and covered and the coupling on the ETR control module with airbag (N2/2) is to be disconnected.

The earlier standard test connector/plug connection is no longer available.

Model 140 

Connector (10-pin) between cockpit and frame floor unit.

Models 202/210 

Connector (2-pin) for front passenger airbag between cockpit and frame floor unit

Models 170/210 

Connector (2-pin) for side airbag on front left/right door.