Remove/install steering idler arm, replacing bearing bush - AR46.40-P-0310A

MODEL 170, 202, 208 

Fig 1: Identifying Steering Idler Arm Remove/Install Components

	Remove, Install
Installation	Replace self-locking nuts
1	Remove drag link (11) on steering idler arm (26)		AR46.40-P-0100C
2	Remove heat shield (26g)
3	Unscrew nut (26b). Pull out bolt (26a) and remove steering idler arm (26) with bearing bush(26k)		*BA46.40-P-1001-05A
4	Loosen clamping screw (26e)		*BA46.40-P-1003-05A
5	Remove bearing bush (26k)	Installation:  The slight offset of the steering idler arm must point towards the collar of the bearing bush/bearing bush
	The steering idler arm is adjusted in a defined position "a" = 19.1 mm on the bearing bush (26k) "a" = 19,1 mm	The adjusted position may be changed by a maximum of 5 mm by correcting the ball point position. If the specified ball point position is not reached within this adjustment range the bearing tube/body is deformed
6	Install in the reverse order

STEERING IDLER ARM

Number	Designation		Model 170	Model 202	Model 208
BA46.40-P-1001-05A	Self-locking nut, steering idler arm to longitudinal frame member bearing bracket	NM	50	50	50
BA46.40-P-1003-05A	Clamp screw, steering idler arm to bearing bush	NM	30	30	30