Detaching and attaching lower steering shaft - AR46.10-P-0500-01B
| Number | Designation | Model 170 | Model 202 | Model 208 | |
|---|---|---|---|---|---|
| BA46.10-P-1002-01B | Clamping screw between lower and upper steering shaft | Nm | 25 | 25 | 25 |
Detaching
- Unscrew hexagon socket bolt (80c).
- Disconnect lower steering shaft.
Attaching
- Push on lower steering shaft (80a) up to the retaining ring at the upper steering shaft.
The hexagon socket bolt (80c, arrow) and the lug on the thrust ring (right arrow) must be in the same position.
The disk spring must be fully preloaded; if necessary this should be fully preloaded by pressing against the steering shaft.
- Screw in and tighten hexagon socket bolt.