Attaching control cable with adjusting switch - AR46.15-P-0550-06B

Models 202, 208 

1. Lock control cable (93c) with adjusting switch (93) in position in the fixing device (93e) and attach at the play adjusters as shown.
   Fig 1: Identifying Control Cable, Adjusting Switch And Fixing Device -- Models 202, 208

   

Model 170 

2. Thread the control cable (93c) of the latching mechanism (95a) through the two brackets (81c, 81d) and lock in position in the fixing device (93e).
3. Attach compression nipple (93g) in the driver (92a) on the steering wheel side in the lower row of clips.
4. Clip driver (92a) onto the thrust piece.
   Fig 2: Identifying Control Cables Components - Model 170

   
5. Attach compression nipple (93h) of control cable (93c) in the lower row of clips of the front driver and clip onto thrust piece.

   

   In the process do not turn the thrust pieces and there should not be any slack in the cable (arrows) between the ball (93l) and compression nipple (93g) or between the compression nipple (93g) and compression nipple (93h).

   Fig 3: Identifying Compression Nipples, Control Cable And Ball