Anti-theft alarm (ATA) control module version coding - AD80.50-P-2000-03A

Model 170 

The following coding must be carried out after replacing the Pneumatic control module (combined) (A37). The ATA functions in the pneumatic control module (combined) (A37) are not activated until coding has taken place. The coding is menu-driven.

Access to variant coding: 

Body - ATA - Variant coding

Correct coding is a prerequisite for correct display for the menus of actual values and actuations as well as fault codes.

Coding options	Selection	Note
ATA national variant	(switch-off delay time for headlamp connection) to supply	National variant only available up to 5/98.
	up to 5/97
	Rest of the World
	(automatic activation)
Anti-towing sensor	YES
	NO
Interior motion sensor (as of 10/99)	YES
	NO
Alarm signal siren (up to 5/98 only )	YES	The national variant for the alarm signal siren is set in an additional submenu.
	NO