Adjust rubber buffers on hinge lever - AR88.50-P-5200-01G
TEST AND ADJUSTMENT VALUES, GAP DIMENSIONS AT HOODS, DOORS AND COVERS
| Number | Designation | Model 170 | |||
|---|---|---|---|---|---|
| BE60.00-P-1003-01A | Gap dimension | Trunk lid to top of rear fender | Dimension "F" | mm | - |
| Trunk lid to bottom of rear fender | Dimension "M" | mm | - | ||
| Trunk lid to rear fender | Dimension "F" | mm | 5.0 (+1/-0) | ||
| Trunk lid to taillamp | Dimension "M" | mm | 5.0 (+1/-0) | ||
| Trunk lid to bumper | Dimension "V" | mm | 8.0 (± 0.5) | ||
| Rear fender to taillamp | Dimension "U" | mm | 3.0 (± 0.5) | ||
| Fig., see | AR60.00-P-0700-01G | ||||
Adjust rubber buffers only when Vario roof is open
- Open locknut on rubber buffer (7)
- Perform basic setting on rubber buffer Remove and turn in rubber buffers until dimension between contact surface and hinge lever is approx. 26 mm (arrow).
- Coat contact surface of rubber buffer on hinge lever (arrow) with chalk
- Close trunk lid
Press trunk lid closed carefully, do not slam!
- Check chalk imprint on rubber buffers.
- Adjust rubber buffers in increments until chalk marks uniform on both sides.
- Close locknut on rubber buffer (7)
- Check adjustment of trunk lid when Vario roof is closed