Removing, installing trunk lid handle with lock cylinder - AR88.50-P-5060G

MODEL 170 as of 1.2.00 

Fig 1: Identifying Trunk Lid Handle With Lock Cylinder Remove/Install Components - Model 170 As Of 1.2.00 (1 Of 2)

Fig 2: Identifying Trunk Lid Handle With Lock Cylinder Remove/Install Components - Model 170 As Of 1.2.00 (2 Of 2)

	Removing, installing
1	Remove cover behind trunk lid handle (1)
2	Unscrew screws (21) and nut (22)	Nut (22) is located on the rear of the left license plate lamp (E19/1). Installation  : Replace sealant on nut (22).
3	Remove cover (2) and disconnect connection leads for left and right license plate lamps (E19/1, E19/2)
4	Unclip connecting rod (11)
5	Pry pneumatic line (31) off with 7 mm open-end wrench
6	Unscrew nut (12)	Installation  : Replace sealant on nut (12).
N	Unscrew screws (13) with plastic washers	Secure trunk lid handle (1) from falling out with one hand.
8	Unclip lock cylinder (3) from trunk lid handle (1) (see arrows)
9	Install in the reverse order