Remove/install lamp unit - AR82.10-P-4730EG

MODEL 170 as of 1.8.99 with CODE (612) Xenon headlamp unit 

Shown on model 170 without CODE (612b) Xenon headlamp unit on left front lamp unit 

Fig 1: Identifying Lamp Unit Remove/Install Components - Shown On Model 170 Without Code (612B) Xenon Headlamp Unit (1 Of 2)

Removal shown on left front lamp unit 

Fig 2: Identifying Lamp Unit Remove/Install Components - Shown On Model 170 Without Code (612B) Xenon Headlamp Unit (2 Of 2)

	Remove/install
	Risk of death  caused by high voltage levels present at xenon headlamps. Risk of explosion/fire hazard  through highly flammable material in the area of damaged xenon bulbs. Risk of injury  through UV light, hot components on xenon headlamps and glass splinters when xenon bulbs burst. Risk of poisoning  through inhalation of mercury vapor and swallowing of or skin contact with toxic salts and mercury compounds.	Do not come into contact with parts that are under high voltage. Persons with active electronic implants  (e.g. heart pacemakers) must never work on xenon headlamps. Switch off complete lighting system. Wear insulating safety shoes, safety glasses and protective gloves. Remove highly inflammable materials from the hazard area. Ensure that the workplace is sufficiently ventilated.	AS82.10-Z-0001-01A
1	Switch off ignition
2	Remove left turn signal lamp (E6/1) or right turn signal lamp (E6/2)	Insert screwdriver into bore (enlarged detail) at the end of the fender support to release the lock and push the turn signal lamp out to the front.
3	Detach electrical connection (3) from left turn signal lamp (E6/1) or right turn signal lamp (E6/2)
4	Detach electrical connection (2) (lamp unit) and electrical connection (4) (headlamp range adjustment motor) on left front lamp unit (E1) or right front lamp unit (E2)
5	Undo screw (9) on front bumper (1)
6	Undo sheet metal screws (8) on radiator grille (6)
7	Remove screws (5) and (7)
8	Pull radiator grille (6) and mounting bracket on front bumper (1) slightly forward	Avoid damage.
9	Carefully remove left front lamp unit (E1) or right front lamp unit (E2) to front	Installation:  Align xenon lamp unit such that the distances between the fender and closed engine hood are equal.
10	Install in the reverse order	Steps 9 to 1.
11	Set zero position on left front lamp unit (E1) or right front lamp unit (E2)	See Star Diagnosis.
	Checking
12	Check and correct headlamp adjustment
		Model 170 except CODE (491) USA version.	AP82.10-P-8260A