Retrofitting radio and navigation operating unit for APS - AN82.61-P-7412-06C

Model 170 

1. Connect connector from auto-pilot system wiring harness (1) and radio connector (3) from standard wiring harness to new radio and navigation operating unit (APS) (A2/29).
2. Connect radio antenna.
   Fig 1: Identifying Auto-Pilot System Wiring Harness And Radio Connector

   
3. Tie back connector (4) with brown ground leads; no longer required.
4. On vehicles with CD changer it is also necessary to install a new wiring harness for the CD changer.
5. Install radio and navigation operating unit (APS) (A2/29).

   See APS operating instructions for decoding and basic settings.

   Fig 2: Identifying Radio And Navigation Operating Unit