Removing and installing fuse and relay box - AR54.15-P-1255EC: Notes

MODEL 170 

Fig 1: Identifying Fuse And Relay Box Remove/Install Components

	Removal, installation
1	Disconnect ground lead from battery		AR54.10-P-0003A
2	Remove cover (1) on fuse and relay box (F1)
3	Unclip cover (3)
4	Unclip fuse blocks (A-D)	Pry carrier (4) for fuse blocks and relays out as far as possible and unclip fuse blocks (A-D) from carrier.
5	Remove closing confirmation relay (K54) from carrier (4) together with holder
6	Disconnect leads from fuse boxes and fuse blocks	Disconnect leads only when replacing entire fuse and relay box. Tie disconnected leads from individual fuse boxes or blocks together and mark to prevent mix-up.
		Models 170, 202 as of 1.12.94, 210 Installation:  ↓ Connect leads to fuse boxes or blocks: ↓	AR54.15-P-1255-01EB
		Models 170, 202 as of 1.12.94, 210	AR54.15-P-1255-02EB
	Assignment and wire connections to fuse blocks		GF54.15-P-1255ED
7	Disconnect connectors	Separate continuous leads at connectors or on component
8	Remove cycle module (5)
9	Remove pedal covering
10	Unhook control cable for unlocking engine compartment in passenger compartment and tie back	Do not kink
11	Unscrew nuts (2)	From inside of vehicle
12	Remove fuse and relay box (F1)	Check gasket (6) for damage and replace, if necessary
13	Reinstall in opposite order

Fig 2: Identifying Unlocking Tool (202 589 03 33 00)