Removing and installing actuator in headlamp unit - AR82.10-P-4301A

MODEL 129 except CODE (612b) Xenon headlamp unit 

Fig 1: Identifying Actuator In Headlamp Unit

	Removal, installation
1	Remove headlamp reflector		AR82.10-P-2850A
2	Turn actuator (1) 45° to left and remove	Do not touch reflector. Ball head should catch audibly.
3	Unclip red retaining clip (2) from actuator (1)	Check seal (3) for damage, replace if necessary.
4	Install in the reverse order
5	Check and correct headlamp adjustment		AP82.10-P-8260A