Adjusting wiper system - AR82.30-P-6400-01A

TEST AND ADJUSTMENT VALUES FOR WINDSHIELD WIPERS

Number	Designation			Model 129
BE82.30-P-1001-01A	Dimension	Distance between wiper gear head and windshield, dimension "A"	mm	5
BE82.30-P-1001-01A	Dimension	See figure		&.2.(AR82.30-P-6400-01A)
BE82.30-P-1002-01A	Dimension	Distance between wiper arm and wiper blade, dimension "B"	mm	5
BE82.30-P-1002-01A	Dimension	See figure		&.2.(AR82.30-P-6400-01A)

Fig 1: Identifying Feeler Gauge (129 589 03 21 00)

Check distance A with feeler gauge.
Press wiper system upward until feeler gauge can be inserted. If the oblong holes do not allow sufficient adjustment, install shims between the rubber mounts and wiper system.

Fig 2: Checking Distance A With Feeler Gauge
Check distance B with feeler gauge.
If the interval is less than 5 mm, bend wiper arm bow in direction of windshield until feeler gauge can be inserted.

Fig 3: Checking Distance B With Feeler Gauge