Remove/install lamp unit lens - AR82.10-P-1820B

MODEL 129 up to 30.5.96 with CODE (491) USA version 

Fig 1: Identifying Lamp Unit Lens (2 Of 2)

	Remove/install
	Risk of death  caused by high voltage levels present at xenon headlamps. Risk of explosion/fire hazard  through highly flammable material in the area of damaged xenon bulbs Risk of injury  through UV light, hot components on xenon headlamps and glass splinters when xenon bulbs burst Risk of poisoning  through inhalation of mercury vapor and swallowing of or skin contact with toxic salts and mercury compounds	Do not come into contact with parts that are under high voltage. Persons with active electronic implants  (e.g. heart pacemakers) must never work on xenon headlamps. Switch off complete lighting system. Wear insulating safety shoes, safety glasses and protective gloves. Remove highly inflammable materials from the hazard area. Ensure that the workplace is sufficiently ventilated.	AS82.10-Z-0001-01A
1	Switch off ignition
2	Remove lamp unit		AR82.10-P-4730A
3	Remove sealing lip (1)	To do so pull up the sealing lip and remove the expansion rivets (2).
4	Unclip retaining tabs (3)	Installation  : The retaining tabs must be heard to latch audibly into place.
5	Remove lens frame (4)	Installation  : Check guides (arrow) are correctly seated. Check or replace seal for signs of damage.
6	Remove screws (5) and lens (6)	Remove lens to the front and detach electrical connection for high beam and low beam (9).
7	Remove mounting ring (7)
8	Remove bulb (8)	Do not grasp the bulb glass with your bare fingers but use a grease-free, soft cloth. Ensure bulb is correctly installed.
9	Install in the reverse order
10	Carry out function check