Remove/install supporting joint on wheel carrier - AR35.20-P-0116-01I

Fig 1: Identifying Extraction And Installation Tool (202 589 00 43 00)

Remove supporting joint 

1. Pull supporting joint out of wheel carrier using the extraction and insertion tool.
2. Remove extraction and insertion tool with supporting joint.

   Shown on model 220 with AIRMATIC 

   Fig 2: Identifying Support Joint And Counterholding Bush - Shown On Model 220 With AIRMATIC

   

   Install supporting joint 

3. Fit the extraction and insertion tool with supporting joint to wheel carrier.
4. Draw supporting joint into the wheel carrier from behind using the extraction and insertion tool.

   Using the thrust piece part 01 (06a) draw in the supporting joint until it abuts the machined contact surface (arrow).

   The supporting joint has been properly inserted when it is in the center of the wheel carrier boss.

   Shown on model 220 with AIRMATIC 

   Fig 3: Identifying Thrust Piece - Shown On Model 220 With AIRMATIC