Removing and installing front seat cushion motor - AR91.29-P-1422N

MODEL 215 

Fig 1: Identifying Front Seat Cushion Motor Remove/Install Components - Model 215

	Removal, installation
1	Move front seat and seat cushion up and unhook tensioning straps (1) at bottom of front seat
2	Position front seat toward front
3	Press tensioning element (2) bottom cover upward (see arrows)
4	Disconnect horizontal seat cushion adjustment servo motor connector (X54/16) from seat cushion forward/back motor (M26m6)
5	Unscrew screw (3) from seat cushion forward/ back motor (M26m6) on seat backrest cross member		*BA91.10-P-1005-01C
6	Unscrew inner Torx screws (4, 4 each) from cushion frame (5) and remove seat cushion forward/back motor (M26m6)		*BA91.10-P-1002-01C
			Figure
7	Install in opposite order
8	Check seat adjustment for proper function

FRONT SEATS

Number	Designation		Model 215
BA91.10-P-1002-01C	Screw for seat cushion on seat adjustment device	Nm	8
BA91.10-P-1005-01C	Screw for seat cushion adjustment device on cross member	Nm	20

Fig 2: Identifying Torx Bit Set (000 589 01 10 00)