Remove/install combination switch - AR54.25-P-2800I

MODEL 215, 220, 230.4

Shown on model 220 with code (494) USA version

Fig 1: Identifying Combination Switch Remove/Install Components - Shown On Model 220 With Code (494) USA Version

MODIFICATION NOTES

21.11.05

Disconnect ground line replaced by switch off ignition

Step 2.2

	Remove/install
1.1	Connect no load current retention unit	on model 215, 220	AR54.10-P-1030-07I
			*WH58.30-Z-1012-09A
2.1	Disconnect battery ground cable	on model 215, 220	AR54.10-P-0003I
2.2	Switch off the ignition and remove the transmitter key from the EIS control unit	in case of model 230 On vehicles with code (889) Keyless Go, press the Keyless Go start/stop button repeatedly until the ignition is switched off. Remove the Keyless Go transmitter card or transmitter key from the vehicle and store beyond the reach of the transmitter (min. 2 m).
3	Remove jacket tube switch module (1)	See:↓
		Remove/install steering column module	AR54.25-P-2802I
4	Install in the reverse order

COMMERCIALLY AVAILABLE TOOLS

Number	Designation
WH58.30-Z-1012-09A	Quiescent current retention unit