Replace brake hoses - AR42.10-P-0013I

Models 215, 220 

Fig 1: Identifying Brake Hoses Remove/Install Components

	Remove/Install
	Risk of poisoning  from swallowing brake fluid. Risk of injury  from brake fluid coming into contact with skin and eyes.	Pour brake fluid only into suitable and appropriately marked containers. Wear protective clothing and eye protection when handling brake fluid.	AS42.50-Z-0001-01A
	Notes on handling brake fluid		AH42.50-P-0001-01A
	Notes on repairs to brake system		AH42.00-P-0003-01A
	Notes on installing brake hoses		AH42.10-P-9406-01A
	Risk of death.  Death may result if vehicle slips or topples from the lifting platform.	Align vehicle between the columns of the lifting platform and position the four support plates at the lifting platform support points specified by the vehicle manufacturer.	AS00.00-Z-0010-01A
1	Raise vehicle.
2	Unscrew brake line (5) from brake hose (51) and seal off openings	When loosening or tightening the brake line (5) on the brake hose (51), take care not to twist the bracket (arrows). Counterhold at two flats of brake hose using open-end wrench if necessary. Seal off line connections immediately with plugs. The brake fluid reservoir must not be allowed to empty completely.
		Box wrench bit	Fig 2
		Brake line at brake hose	*BA42.10-P-1001-04A
3	Unscrew brake hose (51) from floating caliper.	Box wrench	Fig 3
		i Only front axle: Pull out brake hose through rubber grommet at bracket.
		Brake hose to fixed caliper	*BA42.10-P-1002-04A
4	Install in the reverse order
5	Bleed brake system.	Model 215, model 220 without special protection code Z07	AR42.10-P-0010I
		Model 220 with special protection code Z07	AR42.10-P-0010MB

BRAKE LINES, BRAKE HOSES

Number	Designation		Model 215	Model 220
BA42.10-P-1001-04A	Brake pipe to brake hose	NM	14	14
BA42.10-P-1002-04A	Brake hose to fixed or floating caliper	NM	18	18

Fig 2: Identifying Ring Wrench Socket (000 589 75 03 00)

Fig 3: Identifying Ring Wrench (000 589 76 03 00)